As an Amazon Associate I earn from qualifying purchases.
1. Frienda #ad
20 Pieces IR Infrared Obstacle Avoidance Sensor Module 3-Wire Reflective Photoelectric Sensor Module Compatible with Arduino Smart Car Robot Raspberry Pi 3 #adFrienda #ad
- Feature: there is a pair of infrared transmitting and receiving tube of the IR sensor module, tube infrared emit a certain frequency, reflected infrared receiving tube, when the detection direction meets the obstacles reflecting surface, after the comparator circuit processing, green indicator will light up, at the same time signal output interface to output digital signal a low level signal.
Easy to use: the output port out sensor module can be directly connected to the microcontroller port, you can directly drive a 5V relay.
Function: the ir infrared obstacle avoidance sensor module can be applied in robot obstacle avoidance, obstacle avoidance car, black and white line tracking, line count, etc.
Adjustable distance: the detection distance of the infrared module is 2 to 30 cm, and the detection angle is 35 degrees, the distance The distance at which the potential can be detected is adjustable. Application: the ir sensor module can be applied for 3-5V DC power supply modules; There is a red power indicator.
2. Songhe #ad
Songhe IR Infrared Obstacle Avoidance Sensor Module Reflective Photoelectric Module 3pins 3.3V-5V for Arduino Smart Car Robot 10pcs #adSonghe #ad
- When the power is turned on, the red power indicator lights;. Counterclockwise adjustment potentiometer, reducing detection distance. When the module detects an obstacle in front of the signal, while the ouT port sustained low signal output, the distance can detect potential is adjusted clockwise adjustment potentiometer, detection angle 35 °, the module detects the distance 2 ~ 30cm, the green indicator lights on the board level, detects the distance increases;.
The sensor module output port out port can be directly connected to the microcontroller IO can also be directly drive a 5V relay; Connection: VCC-VCC; GND-GND; OUT-IO. The module can be 3-5v dc power supply.
|Model||Obstacle Avoidance Sensor|
3. KEYESTUDIO #ad
Temperture, LED Modules, Programming for Beginners Adults Learning, Gas Sensor, Servo Motor, IR Receiver, 5v Relay, KEYESTUDIO 48 Sensors Modules Starter Kit for Arduino with LCD #adKEYESTUDIO #ad
- Compatible with various micro-controllers and Raspberry Pi, r3 development board, such as mega 2560, leonardo, pro micro, etc. The professional support team is ready to answer any questions.
Note we only offer arduino instructions. All of this makes getting started with sensors quite easy. Download the arduino tutorial from wiki website. This kit Not contains arduino controller board.
This is high quality sensor kit with exquisite packaging. The tutorial shows wiring for the arduino and gives example code. It's a perfect present for junior high and high school inventors, designers, hackers, and tinkerers of all levels.
This electronic sensor kit contains 48 pieces most popular and mainstream sensors and modules, allow you to do a lot devices, robots and other interactive device with the best price. We provide detailed projects for each sensor based on development board, including wiring method, test code, etc.
4. OSOYOO #ad
Receiving Tube, and Photoelectric Switch for Arduino Smart Car Robot Raspberry PI 4 3 Model B, OSOYOO 10PCS Obstacle Avoidance Sensor Module with IR Transmitting #adOSOYOO #ad
- It has a pair of infrared transmitting and receiving tube, green indicator will light up, after the comparator circuit processing, tube infrared emit a certain frequency, when detecting direction meet with obstacles reflecting surface, reflected infrared receiving tube, at the same time signal output interface to output digital signal a low level signal.
Can be used for 3-5v dc power supply modules. The output port out sensor module can be directly connected to the microcontroller IO port, you can directly drive a 5V relay.
The module detects the distance 2 ~ 30cm, detection angle 35 °, the distance can detect potential is adjusted. Ir infrared obstacle avoidance sensor Module can be widely used in robot obstacle avoidance, obstacle avoidance car, line count, and black and white line tracking and so on. It has red power indicator.
5. ACEIRMC #ad
ACEIRMC Digital 38khz Ir Receiver Ir Transmitter Sensor Module Kit for Arduino Electronic Building DIY ， Pack of 6 Sets #adACEIRMC #ad
- Pin definitions: 1 Output 2 Vcc 3 GND. With signal indicating LED, easy to observe and debug. It is suitable for infrared communication, infrared remote control, apply to a variety of platforms including for Arduino/51/AVR/ARM.
Ir infrared transmitter module ir Digital 38khz Infrared Receiver Sensor Module For Arduino Electronic Building Block. This ir transmitter sensor module is directly launched by a single tube, it requires waveform modulation through the program.
6. AITRIP #ad
AITRIP 1PCS AMG8833 88 IR Thermal Camera Sensor AMG-8833 Array Temperature Sensor Module for Arduino Raspberry Pi ESP8266 #adAITRIP #ad
- Maximum frame rate: 10Hz,. Accuracy: + - 2. 5°c 4. 5°f. Temperature measurement range: 0°C to 80°C 32°F to 176°F. Simply supply power and connect the digital communication pins I2C for Arduino, Raspberry Pi, ESP8266, etc. Power supply: 3~5V.
7. Generic #ad
5pcs IR Infrared Obstacle Avoidance Sensor IR Transmitting and Receiving Tube Photoelectric Switch 3-pin Compatible with Ar-duino Smart Car Robot #adGeneric #ad
- The detection distance can be adjusted by the potentiometer knob. It has a pair of infrared transmitting and receiving tubes. The effective range is 2 to 30cm and the working voltage is 3.
3v. 5v. The sensor's detection distance can be adjusted by a potentiometer, has small interference, is easy to assemble, and is easy to use. The sensor module has strong ability to adapt to ambient light. It can be widely used in robots to avoid obstacles, count pipelines, avoid cars, and track black and white lines.
Signal output interface outputs a digital signal a low-level signal. Sensor module output port out can be directly connected with the microcontroller IO port can also directly drive a 5V relay; connection mode: VCC-VCC; GND-GND; OUT-IO. The transmitting tube emits infrared light of a certain frequency.
8. ALMOCN #ad
ALMOCN 15PCS IR Infrared Obstacle Avoidance Sensor Module 3-Wire for Arduino Raspberry Pi Smart Car Robot #adALMOCN #ad
- The output port out sensor module can be directly connected to the microcontroller IO port, you can directly drive a 5V relay. It has red power indicator. Feature: there is a pair of infrared transmitting and receiving tube of the IR sensor module, green indicator will light up, after the comparator circuit processing, reflected infrared receiving tube, when the detection direction meets the obstacles reflecting surface, tube infrared emit a certain frequency, at the same time signal output interface to output digital signal a low level signal.
Detection distance is 2 ~ 30 cm, 35 degree Angle, distance can be adjusted through the detection of potential. It can be used for 3-5v DC power supply modules. Ir infrared obstacle avoidance sensor Module can be widely used in robot obstacle avoidance, obstacle avoidance car, line count, and black and white line tracking and so on.
9. Oiyagai #ad
Oiyagai 5pcs IR Flame Sensor Module Detector Smartsense for Temperature Detecting Compatible with Arduino #adOiyagai #ad
- Fit for Arduino. Total size : 50 x 15 x 15mm/2" x 059"x 059"l*w*h. Accuracy adjustable. Flame detection Sensor Module. Working voltage : 3-5. 5v dc.
10. Teyleten Robot #ad
Teyleten Robot TCS34725 TCS-34725 Color Sensor Colour Recognition Module RGB Light Color Sensor for Arduino 3pcs #adTeyleten Robot #ad
- Brand new original chip. Module input voltage levels Compatible with VDD or 1. 8 v bus. Module data rates can up to 400 kbit/s, power is low, is 2. 5-ua sleep State. Module programmable Upper and Lower Thresholds with Persistence Filter.