As an Amazon Associate I earn from qualifying purchases.
1. RC Electric Parts #ad
30A RC Brushless Motor Electric Speed Controller ESC 3A UBEC with XT60 & 3.5mm bullet plugs #adRC Electric Parts #ad
- 5v/3a ubec very efficient - ESC can power receiver and servos. Low battery protection, signal Loss Protection, startup throttle Protection, Overheat Protection, and Abnormal Voltage Protection.
Comes pre-soldered with XT60 Connector and 3. 5mm bullet plugs. Programmable - Programming Card or using Transmitter. Lipo 2 - 4s cells, nicd/nimh: 5 - 12 cells, 6. 4v - 16. 8v.
2. QWinOut #ad
QWinOut 2-4S 30A RC Brushless ESC Simonk Firmware Electric Speed Controller with 5V 3A BEC with 3.5mm Female Banana Bullet for 2 to 4s Lipo Battery, 4 pcs, DIY Multicopter Quadcopter 30A #adQWinOut #ad
- Extreme low resistance PCB is helpful for getting a super current endurance capability. Microprocessor uses separate voltage regulator IC, with good anti-jamming capability.
Input voltage:2-4 s; bec: 5v 3a; working current: 30A / 40A Optional on my shop. Universal simonk firmware 30a/40a esc brushless speed Controller, super simple. We have set up the program, this items was soldered with 3.
5mm female banana connectors, the ESC do not need additional program. Military standard capacitor of extreme low resistance increases the ability of prevention of unwanted RF noise during flying. Note: 1. Since 202007. 05, effectively avoid welding problems; 2. 30a/40a is optional on my shop. Small size combined with light weight for easy installation.
3. Flycolor #ad
YoungRC 30A ESC RC Brushless Motor Electric Speed Controller 3A UBEC with XT60 & 3.5mm bullet plugs #adFlycolor #ad
- Programmable - Programming card or using Transmitter. Lipo 2 - 4s cells, nicd/nimh: 5 - 12 cells, 6. 4v - 16. 8v. The 30a speed controller comes pre-soldered with XT60 Connector and 3.
5mm bullet plugs. 5v/3a ubec, 2-4s lipo battery, throttle range can be calibrated to be compatible with different transmitters. Low battery protection, signal Loss Protection, Overheat Protection, startup throttle Protection, and Abnormal Voltage Protection.
4. nidici #ad
NIDICI BLHeli-32 30A ESC 32bit Brushless Electric Speed 2-4s Controller for DShot1200 FPV Racing Drone Pack of 4 #adnidici #ad
- Adaptive timing, compatible with a wide range of motors and Kv. Dedicated gate drivers, PMSM, Hardware PWM driver. Stm32f051 48mhz arm 32-bit micro-processor. Blocking protection - if the propeller is blocked from spinning the ESC will automatically stop the rotation to avoid damage.
Motor will automatically rotate again once blockage is removed. 32bit 30a dshot esc compatible 2-4s LiPo battery.
5. Readytosky #ad
Readytosky 30A ESC Opto 2-6S Brushless Speed Controller for F450 S500 ZD550 RC Helicopter Quadcopter #adReadytosky #ad
- 30a opto 2-6s brushless electronic speed controller. Calibrate esc first : https://www. Youtube. Com/watch?v=gYoknRObfOg.
Specifically optimized firmware ESC, the ESC has a very good compatibility. Continuous current: 30A Weight: 28. 5g. Highly intelligent, adaptive ability, extremely easy to use;.
6. Hobbypower #ad
Hobbypower 30a Brushless Speed Controller ESC for X525 Multicopter Helicopter Airplane #adHobbypower #ad
- Battery type: li-xxli-ion or LiPo / Ni-xxNiMh or NiCd. Regardless the throttle stick position, the motor will not spin after battery connected. Full protection features: Low voltage cutoff protection / Over-heat protection / Throttle signal lost.
Brake setting: brake enabled / brake disabled. Throttle calibration: throttle range can be configured to provide best throttle linearity, fully compatible with all market available transmitters.
7. YoungRC #ad
YoungRC A2212 1000KV Brushless Motor+ 30A ESC Electric Speed Controller with Gold Bullet Banana Plugs for RC Multicopter Quadcopter #adYoungRC #ad
- It includes 1x 2212 1000kv brushless motor, 1 x 30A ESC speed controller. Note: firmware cannot be flashed，it is not open source and fixed.
Made of high quality metal and plastic, easy to install, performs well. 30a esc has multiple protection functions, the wrong throttle position is not allowed to start; temperature protection, 110 degree surface temperature shutdown; out of control protection, safe start, no signal after 1 second stop.
The motor is compatible with a variety of brand electrical tuning, widely used in fixed wing, motor efficiency more than 75%, model aircraft, four axis multi rotor aircraft, high precision dynamic balance, etc.
8. Hobbypower #ad
Hobbypower SimonK 30A ESC Brushless Speed Controller BEC 2A for Multirotor Quadcopter4 Pack #adHobbypower #ad
- Soldered with 3pcs 3. 5mm gold female plug, very convenient to connect motor. Highest accuracy with crystal Oscillator Temperature won't affect the PWM operating range like other cheap ESC's.
30a simonk firmware Brushless ESC. 16khz motor frequency, giving fastest response of the motor, and quietest operation as well no 8KHz squeal. Super high refresh rate, no buffering of the input signal, resulting in more than 490Hz response rate.
9. HGLRC #ad
HGLRC 4PCS 30A ESC 3S 4S 5S ESC BLHeli_S Electronic Speed Controller Support Dshot 150/300 / 600 Brushless ESC for FPV Racing Drone Multicopter Quadcopter #adHGLRC #ad
- Ultra-small and light footprint: 2g weight 26*14. 5mm esc with the silicone Signal and Power Wires provides high heat-resistance and more flexibility.
Stable firmware: blheli_s 16. 5 is designed for superior performance in multirotors, and uses hardware upgradable. Strong current endurance: steady input voltage 3S 4S 5S Lipo battery in Continuous current current 30A, max spoort to 40Ain 10s.
Supported protocols: analog signals - multishot, One shot 42, 300, Digital Signals - Dshot 150, Oneshot125, 600. Use top quality components: imported japanese toshiba MOSFETs and Japanese Murata Ceramic Capacitors. 3oz high-tg pcb board significantly reduces electrical heat soak and improves system efficiency.
|Part Number||HGLRC 4PCS ESC|
10. powerday #ad
Powerday 30A ESC Brushless Speed Controller BEC 2A for Quadcopter F450 X525Pack of 2 #adpowerday #ad
- Current: 30a -max. For sale is 2pcs 30a simonk firmware brushless ESC. Input voltage: 2-3s lipo / 4-11 cell Ni-MH/Ni-Cd. Size: 55x26x8mm length 145mm including power cable -Weight: ~22g.
Cont. Current: 35a - bec: 5v 2A Linear mode）. Soldered with 3pcs 3. 5mm gold female plug, very convenient to connect motor.